Using the photo above line up the letter opener on the small slide and make sure that the blade curves down (this only applies if you are using the same letter opener as me). If you use the letter opener I used you will already have a hole drilled into it and will only have to drill three more holes. However, if you want something that looks a little more lethal and want to make your own blade just understand that where we drill our holes may be a little different. Make sure after all your cuts you grind down the edges to make it smooth.įor my Xiphoid I decided to use a letter opener as the blade. Once you have marked it go ahead and cut it. Take the Large Slide and measure out 9 7/8" (if you go with 10" it's not a big deal, I'm just going with what worked for me the first time). MAKE SURE THAT YOU HAVE A CONTAINER OR MAGNET TO CATCH ALL THE BALLS WHEN YOU SLIDE OUT THE SLIDER. Once you have removed this notch you should be able to slide each part out. Just make sure to keep the hole within where you cut so that you won't have to drill another one. In the photo above you can see where I cut Large Slide, the angled cuts are purely for aesthetics so it doesn't matter if you prefer to cut straight down. You need to remove this piece in order to modify each piece. Once you have done this you'll notice a notch in the Large Slide that prevents the other pieces from falling out. To do this you need to fully extend the slide. Now you need to separate the slide into its three parts which I call the Large Slide, the Slider, and the Small Slide. You won't be needing these pieces so you can toss them away. Where the tape was is a part that you can slide off, remove it. On the back there should be some tape that you need to pull off. The first thing you need to do is take apart the draw slide.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |